The Laminar Covers assemby is quite simple.

 

The pack includes:

 

     - One cover, plain, for the cassette side.

     - One cover, lens-shaped for the opposite side.

     - 10 polyamide screws (male and female y hembra). 8 for the assembly and 2 spare screws.

     - Carbon fiber made in order to cover the valve hole.

 

The necessary tools are (not included)

 

     - a chain whip

     - cassette cog remover tool

     - wrench

 

 

 

 

 

 

The steps to install the laminar cover are the following:

 

1.Remove the cassette and the spacers.

2. Install the lens- shaped cover. You can use a tupperware or something similar to hold it.

3. Install the plain cover (drive-side), aligning the mark (inside) with the valve hole.

 

The cover will not be supported int the hub base yet. That is OK. When you install the screws it will be slowly moving down to the correct place.

 

4. Install the screws with your fingers. Do not tighten too much or some warpage could arise. If it appearrs remove them and try it again, with less pressure.

Check that the plain cover hole is centered with the hub.

5.Install the cassette.

 

6.Comprobar que la cadena no roza en la tapa plana.

 

Como comprobación previa: si antes de montar la tapa, asegurar que existe una holgura entre los radios y el último piñón de 5 mm. Si es así, después de montar la cadena no debería rozar con la tapa. Si la separación es menor, probablemente habrá que colocar algún separador en el buje antes de colocar el cassette.

7.Pegar la pieza de carbono para tapar el orificio de la válvula con cinta aislante.

El resultado debería parecerse a esto: